Last Updated: May 19, 2018
Important notes:
First time this software is uploaded, the fixture will update the User Interface firmware. This can take up to a couple of minutes, and the display will be black during this update.
Fixture must have MACIII Profile - Firmware ver. 1.5.0 or later to accept this software
New features:
- Performance module support
- Red dot added to user interface, while flashing data is being saved into the modules. If the fixture is turned off while the dot is flashing, data may be lost
- Shutter blackout option added
- Gobo X-fade menu added
Improvements / Bug fixes:
- Improved USB mass storage support
- Improved DMX upload stability
- Reduced lamp cooling after lamp on
- New UI firmware that will prevent display failure (display going black). Note: It may be able to revive a black display, depending on the severity of the damage
- All calibration values are now saved in the modules
- Error codes are now flashed 3 times, before the next error is shown
- Various RDM improvements
- If non-essential modules are missing, an error is shown, but the fixture will continue to run
- Support for nand flash boot added
- Performance basic shapes changed to match manual
DMX Protocol changes:
- No changes to the DMX protocol in this version of the firmware
download
