Zuletzt aktualisiert: 22. Mai
- Fan control added. When lamp has been off for 15 minutes, the lamp fan turns off and the PSU fan slows down.
- Added "MCOFF" to the MP2 menu. This assigns a lamp-off command to MC-X preset key 7.
- Added visual channel indication in MP-2 single address mode. GREEN light indicates the START channel, YELLOW light indicates a channel between START and STOP channels, and RED light indicates the STOP channel. No light (dimmer closed) indicates a channel outside the fixture´s channel space.
- Dmx loader prepared for new processor steps (safer upload)
- When leaving MP2 mode fixture returns to SA mode if nessecery.
- When entering MP2 programming mode Lamp on if activated
- Use DMX mode upload instead of boot mode if checksum error occurs. (Flashing yellow/red LEDs indicates fixture ready for software upload) - Corrected function of DMX reset ON/OFF commands. DMX reset is now enabled when ON is selected and disabled when OFF is selected.
- Fixed bug that caused unpredictable behavior of magenta flag when stepping through SA scenes during programming and the first run after editing.
- Random colors now agree with DMX protocol. Before 1.2, when selecting MY you would get CY and when selecting CM you would get MY.
- Fixed bug in 1.1 and previous versions that caused the fixture not to respond if the stop channel was the last DMX channel sent (typically 512).
- Fixed a bug in MP-2 single address mode: The fixture "thought" that its address was 2 lower that it actually was.
- Fixed a bug that could cause LEDs and LAMP ON / LAMP OFF commands not to work.
herunterladen
